Customization: | Available |
---|---|
Certification: | ISO9001:2008, SGS |
Application: | Copying Machine |
Still deciding? Get samples of $ !
Request Sample
|
Suppliers with verified business licenses
Audited by an independent third-party inspection agency
The steel body cutting spiral knife is especially suitable for the extensive processing method of the domestic solid wood factory. The knife edge is sharp, the bending and compression resistance is strong, the deformation is not easy, the material is deep, and the cutter body is finished by Mazak equipment, with high precision and good dynamic balance. It runs smoothly and is more labor-saving than conventional knives. Trimming, milling, and planing are preferred tools.
1. Replacing knives is easy and doesn't require alignment: As you can see in the picture above, all knives are fastened with a screw through a hole in the center of the knife. The knives are sitting in a matching pocket that keeps the knife in perfect alignment. When installing new knives, simply let the screw guide the knife into the correct spot.
2. Your dust collection system works better: When you are cutting a 10 inch wide board in your planer with a standard cutter head, you create 10 inch wide wood chips that your dust collection system has to suck up. The KWS HELIX head only cuts 15mm (about ½ inch) at any given time and therefore, the wood chips are much smaller. Smaller wood chips are much lighter in weight which is why your dust collection system sucks them up much easier.
3. Necessary replacements of knives cost a fraction in most cases: When knives become dull, you have to re-sharpen or to replace them. In actual fact, most replacements become necessary when a hidden nail or rock in the wood chips out your knives and they now leave ugly and uneven patterns in the wood. When this happens with a KWS HELIX head, usually only one or 2 small knives are affected. As the knives are sharp on all four edges, a simple turn of 90 degrees solves the problem without a knife replacement.